Hiley Tiger EVO GTR UnboxingUpdated 5 days ago

Setting up your new Hiley Tiger EVO GTR electric scooter correctly is the single most important step for your safety. This process is also available in video format:

🎁 Unboxing Your Scooter

1. Open the Box: Use a box cutter or knife to open the box and fold open the top.

2. Check Contents: Inside, you should see protective styrofoam along with the following items. Contact the support team immediately if any are missing:

   • Tiger EVO electric scooter

   • Display introduction and Tiger EVO user's manual

   • Protection*2

   • Rubber Screw Cover*2 For All Models

   • Allen Key Set

   • Charger and cable

3. Remove Scooter: With the help of someone, remove the scooter from the box and place it on a flat surface. Using a stool or bench is recommended so the wheels can spin freely.

4. Remove Protective Material: Carefully remove the protective material from the scooter and set it aside. You should keep both the styrofoam and the box in case you need to ship your scooter back. Otherwise, recycle the materials.

🛴 Assembly Steps

1.Unfolding

1. Unhook: Ensure the hook is not clipped into the rear foot rest. If it is, push down on the stem and unhook it from the rear foot rest.

2. Unfold Stem: Unfold the stem by pulling it up to a completely vertical position.

3. Lock Latch: Locate the folding latch and bring it up, locking the stem. This will require some force to lock fully upright.

4. Engage Safety Button: Make sure the safety button of the folding mechanism is clipped into the stem. 

⚠️ WARNING: Always ensure the safety button of the folding mechanism is clipped into the scooter stem and the stem is fully secured before riding. Failure to do so can lead to loss of control, serious injuries, and death. Do not operate the scooter if you notice anything wrong with the stem, safety button, or locking mechanism.

2. Attach Handlebar

1. Connect Cables: Remove the four hex screws from the handlebar. Connect the male connection cable coming out of the handlebar into the female cable coming out of the front stem. Make sure the pins are aligned. Be careful not to damage the cable.

2. Insert and Tighten: Insert the handlebar at the top of the front stem and tighten it into place with the four hex screws provided.

3. Adjust and Tighten Controls: The latches and buttons on your handlebar may be loose to avoid shipping damage.